5
STEP 8
STEP 9
Attach a Drum Mounting Plate to
the top of each Track Guide using
5/16'' x 1-1/4'' bolts with flange
nuts. The square cradle (spring
side) goes on the left and the
round cradle (bearing side) is on
the right.
IMPORTANT
: Use the bottom
hole of each set of holes.
Bottom Hole
(Set 1)
Bottom Hole
(Set 2)
Drum Mounting Plate
(Spring Side)
Drum Mounting Plate
(Bearing Side)
Place the assembly into the doorway
opening. The bottom of each Guide
Track should be resting on the floor.
The front edge of the Drum Mounting
Plates should be flush with the front
edge of the door jamb tight against
the header. Make sure the assembly
is plumb. Mark the 4 mounting holes
on each of the jamb.
Remove the assembly and drill the holes. If the
jamb is wood, a lag screw with washer is all
that is needed. If the jamb is concrete or steel
& concrete, a wall anchor should be placed in
each hole.
Stand the assembled unit upright and lean it against a
wall. Place the Screen Roller Drum into each Drum
Mounting Plate.
The Spring Locking Clip (square shaft) should be to the
left and the Bushing/Bearing (round shaft) to the right.
STEP 10
Guide
Track
WARNING
The spring tension for the Roller Tube
is pre-set at the factory and is shipped
with the Lock Plate in place. DO NOT
remove the plate until the assembly
process is completed. Also DO NOT
remove the Roll Ties until the Roll
Tube is secured to both End Plates.
Bushing/ Bearing
Screen on
Roller Drum
Spring
Locking Clip
Roll Ties
Front edge of
Drum Mounting Plate
flush with
front edge of
door jamb
tight against
the header
STEP 11
Spring
Loading
Clip
Bushing/Bearing
