Read and Save These Instructions
To Reduce the Risk of Injury, Observe the Following:
Warning
• Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
• Installation work must be done by a qualified person(s) in accordance with all applicable codes and standards.
• When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Please read the “READ THIS FIRST” note on the front cover of this manual before proceeding.
TYPES OF DOORS
2
There are a variety of doors used at both industrial
and commercial facilities. Each has its specific
opening/closing mechanism. This Screen-Pro unit
has been shipped with hardware to accommodate
an In-Jamb Mounting Method. It should be mounted
inside a plain doorway opening using the door
jambs to attach the Guide Tracks.
PLAIN
DOORWAY
OPENING
OVERHEAD
DOOR
ROLL-UP
DOOR
4
Screen Material with
Modular Panels
(Attached to Roller Drum)
Pull
Straps
Lock
Strap
Guide
Tracks
Top Spreader
Angle
Brush Seal
Bar
Brush Seal
Screen Roller Drum
Mounting
Angles
Drum
Mounting Plate
(Spring)
Drum
Mounting Bracket
(Bearing)
Rollover
Straps
SCREEN-PRO COMPONENTS
–IMPORTANT –
This Screen-Pro model has been designed
to fit inside a doorway opening that has an
8'' jamb width or larger.
It is recommended that two people
install the door together.
The following tools will be needed
for installation:
• Carpenter’s Level (Min. 4’ Length)
• Carpenter’s Square
• Hammer Drill
• Masonry Drill Bit (For
3
/
8
” Diameter Anchors)
•
3
/
8
” Diameter and Various Wall Anchors
• Assorted Shim Stock
• Socket and Wrench Set
• Hand Tools
• Four Bar Clamps (36” Long)
• Two Ladders
• Forklift (Supplied by Dealer or Customer)
REQUIRED TOOLS
