PART VI: Troubleshooting and Parts List
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and
their solutions. If you continue to experience problems, contact the dealers in your area.
WARNING
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes to allow
all parts to cool. Disconnect the spark plug wire, keeping it away from the spark plug.
Troubleshooting Table
SYMPTOM
POSSIBLE CAUSE
The engine won’t start.
(Please refer to the
engine user manual
for engine-specific
procedures.)
Is the SAFETY BAR HELD DOWN to engage the safety cutoff switch?
Is the fuel shut-off valve on? SLIDE THE LEVER ALL THE WAY TO THE
RIGHT
Are you using fresh, clean gas? If the gas is old, change it. Use a fuel
stabilizer if you keep gas longer than 30 days.
Is the spark plug clean? If the spark plug is dirty or cracked, change
it. If it’s oily, leave it out, hold a rag over the plug hole and pull the
recoil cord several times to blow out any oil in the cylinder, then wipe
off the plug and reinsert it.
The engine lacks power
or is not running
smoothly.
(Please refer to the
engine user manual
for engine-specific
procedures.)
Check that the Throttle Lever is in the “RABBIT” position. TURN OFF
THE CHOKE
Is the air filter clean? If it’s dirty, change it following the procedure in
the engine manufacturer’s owner’s manual.
Is the spark plug clean? If it’s fouled or cracked, change it. If it’s oily,
leave it out, hold a rag over the plug hole and pull your recoil cord
several times to blow out any oil in the cylinder, then wipe off the
plug and reinsert it.
Are you using fresh, clean unleaded gas? If it’s old, change it. Use a
fuel stabilizer if you keep gas longer than 30 days.
Does your engine have the right amount of clean oil? If it’s dirty,
change it following the procedure in the engine manufacturer’s
owner’s manual.
Check the oil level and adjust as needed.
Engine smokes.
(Please refer to the
engine user manual
for engine-specific
procedures.)
Check the oil level and adjust as needed.
Check the air filter and clean or replace if needed.
You may be using the wrong oil—too light for the temperature. Refer
to your Engine Owner’s Manual for detailed information.
Clean the cooling fins if they’re dirty.
Machine does not seem
to have full grinding
The belts may be too loose and slipping. Adjust or replace belts as
needed.
W W W . T M G I N D U S T R I A L . C O M
P 1 8 / 2 2
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
