Solaris Mozart One user manual version 1.2 041719
- 5 -
Do not allow contact between the common and the fixture’s chassis
ground. Grounding the common can cause a ground loop, and your fixture
may perform erratically. Test cables with an ohm meter to verify correct
polarity and to make sure the pins are not grounded or shorted to the shield
or each other.
S
ETTING UP A
DMX
S
ERIAL
L
INK
1. Connect the (male) 5-pin connector side of the DMX cable to the output (female) 5-pin connector of the
DMX console.
2. Connect the opposite end of the cable (female) to the input connector of the Mozart Drive consisting of a
(male) 5-pin connector.
3. Proceed to connect from the Drive output as stated above to the input of the following Drive and so on.
4. Continue linking until the last fixture is conected in your DMX chain.
F
IXTURE
L
INKING
