TM Induction Heating SURETHERM 10X, Руководство пользователя

Страница: 22 / 36

TM INDUCTION HEATING 22 ST 2.0 |
If a loud vibrating noise is heard:
`
Stop the heating cycle by pressing the start/stop button.
` Are the contact surfaces clean and greased sufficiently?
` Are the yokes 100% in contact with the surface? If this is not the case
adjust the yoke with instructions below.
1. Check if the machine milled surface is smooth.
2. Place yoke or pivoting yoke on the heater.
3. Unscrew the screws in the yoke and pivoting point a quarter turn.
4. Turn on the heater and the yoke will set itself or use a nylon hammer.
MALFUNCTION
7
ADJUSTING
THE YOKE
4 3 2 1
5. Fasten screws, turn off heater and the yokes are now adjusted.
If in any doubt, isolate the induction heater and contact your local
distributor. You can find the contact details for your nearest distributor
on www.tminductionheating.com/distributors .
WARNING