172-65168MA-04 (SA3) 1 Oct 2021
8
Disassembly/Reassembly
When disassembling or removing the product, wait until the internal
pressure equals atmospheric pressure and the surface of the product
has cooled to room temperature. Disassembling or removing the
product when it is hot or under pressure may lead to discharge of fluids,
causing burns, other injuries or damage.
CAUTION
Be sure to use only the recommended components when repairing the
product, and NEVER attempt to modify the product in any way. Failure to
observe these precautions may result in damage to the product or burns
or other injury due to malfunction or the discharge of fluids.
CAUTION
Use the following procedures to remove components. Use the same procedures in
reverse to reassemble. (Installation, inspection, maintenance, repairs,
disassembly, adjustment and valve opening/closing should be carried out only by
trained maintenance personnel.)
Disassembly/Reassembly
Part
Disassembly
Reassembly
Base
Remove with a wrench
Consult the table of tightening torques
and tighten to the proper torque
Body Gasket
Remove the gasket
Replace with a new gasket
Siphon Rod
Remove the siphon rod
Attach the siphon rod to the base
Vinyl Tube,
Worm Drive Clamp,
Clamp Screw
Loosen the clamp screw with a
Phillips screwdriver and
remove the worm drive clamp;
remove the vinyl tube from the
valve seat
Reattach the vinyl tube to the valve
seat, reattach the worm drive clamp,
and then tighten the clamp screw with
a Phillips screwdriver
Valve Seat Holder
Remove with a wrench
Consult the table of tightening torques
and tighten to the proper torque
Valve Holder (Valve),
Coil Spring
Remove from the body
Replace with a new valve together
with a valve holder if the valve is
misshapen or damaged
Insert the valve holder into the hole in
the float
Float
Remove from the body
Snap Ring
Remove with a needle-nose
pliers
Insert securely into the slot
Valve Seat
Remove from the valve seat
retainer
Replace with a new valve seat if
damaged
Be careful not to damage the seating
surface
O-Ring
Remove the o-ring
Replace with a new o-ring; be sure to
coat the o-ring with heat-resistant
grease
Table of Tightening Torques
Part
Torque
Distance Across Flats
N
m
(lbf
·
ft)
mm
(in)
Body, Base
15
(11)
32
(1
1
/
4
)
Valve Seat Holder
8
(5.9)
12
(
15
/
32
)
(1 N
m
10 kg
cm)
