TLV JH8R-P, Инструкция по эксплуатации

Страница: 11 / 18

172-65465MA-04 (JH8R-P) 11 May 2018
10
Disassembly/Reassembly of Components Inside the Body
NOTE: The plug (inside the body) must be removed before the float can be removed.
Part During Disassembly During Reassembly
Plug (inside
the body) Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
Plug Gasket Remove the gasket and clean
sealing surfaces Replace with a new gasket; coat surfaces
with anti-seize
Snap Ring Pinch insides together and
remove from the body Insert securely into the groove in the
body
Screen Remove by grasping the wire ring
and lifting straight up and out Set the screen on the screen holder and
screen holder retainer and insert as far
as the snap ring groove
Screen Holder
Retainer Remove without bending Place on the screen holder without tilting
Screen Holder Remove without bending Place on the ledge inside the body,
making sure the rounded side is on top
Float Remove, being careful not to
scratch the polished surfaces Insert, being careful not to scratch the
polished surface
Outlet Cover
Nut Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
Outlet Cover Remove, being careful not to
scratch the gasket sealing
surfaces Make sure there are no pieces of the old
gasket left on the sealing surfaces of the
body and cover
Outlet Cover
Gasket Remove the gasket and clean
sealing surfaces Replace with a new gasket
Orifice Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
Orifice Gasket Remove the gasket and clean
sealing surfaces
Replace with a new gasket; coat surfaces
with anti-seize
Table of Tightening Torques
Part Name
Torque Distance Across Flats
N
⋅
m
(lbf
∙ft)
mm (in)
Orifice 1000 (730) 60 (2
3
/
8
)
Cover Nut 450 (330) 36 (1
13
/
32
)
Outlet Cover Nut 160 (115) 24 (
15
/
16
)
Cover Plug (JH8R-P) 100 (73) 26 (1)
Plug (inside the body) 150 (110) 27 (1
1
/
16
)
Drain Plug 100 (73) 26 (1)
NOTE: -Coat all threaded portions with anti-seize.
-If drawings or other special documentation were supplied for the
product, any torque given there takes precedence over values
shown here.
(1 N
⋅
m
≈
10 kg
⋅
cm)