172-65452MA-04 (JH5RL-B/JH5RH-B) 18 Nov 2020
9
Disassembly/Reassembly
NEVER apply direct heat to the float. The float may explode due to
increased internal pressure, causing accidents leading to serious injury
or damage to property and equipment.
WARNING
Use hoisting equipment for heavy objects (weighing approximately
20 kg (44 lb) or more). Failure to do so may result in back strain or other
injury if the object should fall.
CAUTION
When disassembling or removing the product, wait until the internal
pressure equals atmospheric pressure and the surface of the product
has cooled to room temperature. Disassembling or removing the
product when it is hot or under pressure may lead to discharge of fluids,
causing burns, other injuries or damage.
CAUTION
Use the following procedures to remove components. Use the same procedures in
reverse to reassemble. (Installation, inspection, maintenance, repairs, disassembly,
adjustment and valve opening/closing should be carried out only by trained
maintenance personnel.)
Drain Plug (Option)
Part
During Disassembly
During Reassembly
Drain Plug
Remove with a socket
wrench
Consult the table of tightening torques and
tighten to the proper torque
Drain Plug
Gasket
Remove the gasket and
clean sealing surfaces
Replace with a new gasket; coat surfaces with
anti-seize
Detaching/Reattaching the Cover
Part
During Disassembly
During Reassembly
Cover Nut
Remove with a socket
wrench
Consult the table of tightening torques and
tighten to the proper torque
Cover
Remove by lifting up and off Make sure there are no pieces of the old gasket
left on the sealing surfaces of the body and
cover, then reattach, lining up the connector
Cover Gasket Remove the gasket and
clean sealing surfaces
Replace with a new gasket
Connector
Remove the connector
Reinsert into hole in body
Connector
Gasket
Remove the gasket and
clean sealing surfaces
Replace with a new gasket
Disassembly/Reassembly of Components Inside the Cover
Part
During Disassembly
During Reassembly
Snap Ring
Pinch the insides together
and remove from the cover
Insert securely into
groove
Air Vent Screen
Remove, being careful not
to misshape
Replace, being careful not
to misshape
Bimetal Plate/Air
Vent Valve
Plug/Snap Ring
Remove air vent parts from
cover
Make sure to reinsert in
the proper orientation
(Fig. A)
Air Vent Valve
Seat
Remove with a socket
wrench
Consult the table of
tightening torques and
tighten to the proper
torque
Air Vent Case
Remove from the cover
Place it in the cover
