EF200R-C
18
8 mm
1.
3.
2.
~
20°
4.
5.
A0041608
1.
Loosen the securing clamp of the transmitter housing.
2.
Turn the transmitter housing clockwise by approx. 20
°
.
3.
The connection board of the wall housing is connected to the electronics board of the
transmitter via a signal cable!
►
Pay attention to the signal cable when lifting the transmitter housing!
Lift the transmitter housing, plug the signal cable out of the connection board of the wall
holder and remove the transmitter housing.
4.
Release the cable gland and insert the connecting cable (use the shorter stripped end of the
connecting cable).
5.
Wire the connecting cable → Fig. 2, See 19 → Fig. 3, See 19.
6.
Reverse the removal procedure to reassemble the transmitter housing.
7.
Firmly tighten the cable gland.
Connection via terminals
