AERO-107
Manual TLR Drones
6
Step 3: If LiPo charge is not selected when you power on the charger press the Batt Type (the
left-most button) until it says LiPo then press the start button on the far right.
Step 4: After selecting Li Po, pressing the start button again will allow you to change the
amps. Change this according to the battery you are charging by going left or right using the
two buttons in between Batt Type and Start. Charge the 6600mAh battery at 5.0A
Step 5: After selecting the correct amount of amps, press start again. This will allow you to
change the number of cells. The 6600mAh battery is labeled a 4 cell battery, so charge it at 4S.
Step 6: After choosing the proper amps and cells, hold down the start button. After the
battery, check press start again to start the charge. When the battery is full the charger will
beep.
Содержание AERO-107
Страница 37: ...AERO 107Manual TLR Drones 36...