Page | 11
TrueLifeAudio
WARNINGS AND MAINTENANCE
Due to the vacuum tubes used in the
TrueLife Audio
design, it is normal that the unit feels a bit warm after many
hours of operation. Proper ventilation will be needed as described in section preparation for installation.
Before you disconnect the mains the Phono Preamplifier has to be in operating condition OFF.
Replacing the Tubes
Before you take any action, please unplug the power cable of the unit from the mains. After unplugging let at least one
hour to pass before you proceed with the replacement of the tubes.
Your
SSP-2
Phono Preamplifier uses six tubes in total, two tubes type 12AX7, two tubes type 12AU7 and two rectifier
tubes type EZ81. In the case that the tubes need to be replaced, follow the steps in the paragraph bellow.
The Phono Preamplifier has one top cover that actually consists of three pieces but can be removed as one panel. In
order the top panel to be removed for replacing the tubes, you just have to remove four screws closer to the front
plate, then three screws closer to the back plate and finally two more on the side panels holding the middle piece. In
total nine (9) screws need to be removed.
Closer to the Phono Preamplifier
‟s rear panel are the two type 12AU7 tubes, one for each channel. The two type
12AX7 tubes are located on the middle of the unit and finally the two rectifier tubes type EZ81are located closer to the
front panel. The type of each tube is marked on the PCB (printed circuit board) in anyway.
Please use only premium quality tubes that you can purchase from the local
TLA
dealer or directly from the
manufacturer.
Mains
Unplug your
SSP-2 Phono Preamplifier
from the mains connection in the following cases:
- before you manipulate with cables
- before you clean your amplifier
- during thunder storms or
- before you leave for longer periods
Cleaning
Please use a soft towel for the cleaning of your Phono Preamplifier. We recommend the use of a nonabrasive micro
fiber towel. Please do not employ any solvents.
Security advice
Liquidity is not allowed to enter the Phono Preamplifier. The electronic may be damaged seriously.
Packing
Please keep the original packing for future transports. The original packing is optimal protection against potential
damages.
Service Policy
If service is needed
Your dealer will have all relevant information about the service centres in your area, and will ensure that your unit is
serviced without delay. It is our general policy to have your unit returned to you within 20 working days. This is an
average time, and could vary locally, depending on the workload at the service centre.
If, for some reason, there are no service facilities available in your country, please ship the
SSP-2 Phono
Preamplifier
to the following address:
