TLA CTS-5-C, Руководство пользователя, Страница: 12 / 32

5
Tap key "E" briefly:
The device operates now in tune
mode.
Display:
Now strike the tone a' on your instrument. Two green illuminated sets of beads appear on the
stroboscopic display. The beads move to the left if the tone is too low, or to the right if the tone
is too high. As the tone approaches the desired pitch, the movements will slow down. At the
correct pitch the beads will stop moving. You can recognize larger frequency deviations, when
one of two green dots on the left or right of the stroboscopic display is lit. Depending on whether
the desired tone is too high or too low, either the right or the left dot will be lit continuously. If
neither of these dots shines, the tone played is at the desired pitch of less than 4 cent.
For tuning the next higher semi-tone, tap key ">" briefly. This
raises the CTS-5-C by one semi-tone.
Similarly, if you tap key "<", you lower the CTS-5-C by one semi-
tone.
Constantly depressing key "S" and simultaneously tapping key ">"
briefly, will raise the device by one octave.
Constantly depressing key "S" and simultaneously tapping key "<"
briefly, will lower CTS-5 by one octave.
If you depress either key "<" or ">" constantly, the desired function will repeat itself every 0.5
seconds.
2.1.1 Automatic note adjustment
Now depress key "A":
The device now automatically follows the tone level of the
played tone. The automated switching was intentionally
limited to two semi-tone steps, to avoid undesired tuning of
partial tones. For the same reason the automatic mode is
not available for the two lowest octaves.
Again depressing key "A" switches off the AUTOMATIC MODE.
2.1.2 Audible tone on/off
Activate tone: When you keep the ”S“ key pressed and tap “A”, you will hear the tone at the
currently desired frequency.
Release both keys.
Deactivate tone: Keep “S“ key pressed and tap “A” again.
Increase volume: While keeping “S” pressed, press “A” twice again for higher volume.
2.1.3 Bargraph Display
In the tuning mode, you can switch between the bar graph and the concert pitch display with the
“E” key.
Press the “E“ key. When you now strike the tone a1 on your
instrument, the arrow points to the right, if the tone played is too high,
and to the left, if it is too low.
a-1 CENTS: 00.0
<1> PITCH:440.0
a-1 CENTS: 00.0
<1> PITCH:440.0
a-2 CENTS: 00.0
<1> PITCH:440.0
a-1 CENTS: 0.0
<1A> PITCH:440.0
Automatic on
Note to be tuned
Cent- adjustment
Mode Number
Concert pitch
a-1 CENTS: 00.0
|-->
bb CENTS: 00.0
<1> PITCH:440.0
a CENTS: 00.0
<1> PITCH:440.0