5.3
Power the camera
The BC820v2 supports 24 Vac / 24 Vdc / 12 Vdc via terminal block and Power over Ethernet
(802.3af PoE). The BC820v2 consumes 3.8 W of power.
To power the BC820v2 with DC 12 V / DC 24 V / AC 24 V
1
If necessary, insert the leads from your power source into the supplied power connector,
as indicated by the connector labelling.
2
Insert the power connector plug into the ADAPTOR connector on the back panel.
3
Plug the power supply into a mains outlet.
To power the BC820v2 with Power over Ethernet (PoE)
● Connect the NETWORK RJ-45 connector on the back panel of your BC820v2 to an
appropriate network switch.
Powering with PoE requires that IEEE 802.3AF Power Sourcing Equipment (PSE) is
available on the network.
● Use Cat 5 Ethernet cable up to 100 m in length.
Connect to a hub or switch with straight-through cable.
Use crossover cable to connect directly to a PC.
5.4
Connect to network
Category 5 Ethernet cable is recommended for network connections. For the best transmission
quality, do not exceed a cable length of 100 metres.
To connect through a hub or switch
● Connect one end of a straight through Cat 5 cable to the RJ-45 connector of the All-in-One
cable and the other end of the cable to the network switch.
To connect directly to a PC
● Connect one end of a crossover Cat 5 cable to the RJ-45 connector of the All-in-One cable
and the other end of the cable to the PC.
Refer to the following figure to determine whether you have established an Ethernet
connection.
Ethernet socket LEDs green/yellow
Green on/off : 100/10 Mbit
Yellow on/blink : link OK, active
Yellow off/flash : link down, TX attempt
Connect the camera
17
