the network. Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network.
Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to
be reset first.
To confirm Inclusion or Exclusion hit the button on the device.
Operating the device
The device is able to dim electric load up to 3500 W. Short press of the button will toggle. This means that
the power will be turned on if it was off and turned off when it was on.
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can
adapt the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow to configure signed values. In order to set values in the range 128
… 255 the value sent in the application shall be the desired value minus 256. For example: to set a
parameter to 200? it may be needed to set a value of 200 minus 256 = minus 56. In case of two byte value
the same logic applies: Values greater than 32768 may needed to be given as negative values too.
LED- Behavior (Parameter Number 1, Parameter Size 1) defines the behavior of the blue LED
Value
Description
0
blue indicates off (Default)
1
blue indicates on
Command Classes
Supported Command Classes
Basic (version 1)
Binary Switch (version 1)
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 3
