TKA SP-C61T, Руководство по установке

Страница: 9 / 23

9
Tap Setting Knob
When using the SP-C61T speakers with a low impedance system
(such as with a 4Ω or 8Ω amplifier), make sure that the tap setting
switch is set to the 8
Ω position. This is the only appropriate setting
when using the SP-C61T speakers with a low impedance
amplifier.
Prewiring
Run a separate 2-conductor stranded copper speaker cable of at least 16 AWG (~1.5
mm
2
) from the amplifier to each speaker. Be sure to use cable with the appropriate fire
resistance rating for the application.
When running a speaker cable parallel to an AC power cable, keep them at least 12
inches (30cm) apart to minimize electromagnetic interference. If the speaker cables
must cross AC wirings, cross them at right angles.
Leave about 2 feet (0.6m) of cable at each end for connecting to the speakers and
amplifier. Label the cables so you will know which cable connects to a volume control
keypad or amplifier output channel.

Avoid running speaker wires close to electrical wiring for any distance. If you have
to run them parallel, leave two feet (0.6m) between the wiring. Speaker wires
should cross AC lines at a 90° angle.

The entire path between speakers and amplifier should be clear and unobstructed.
Confirm placement for a cable exit close to the intended location of the amplifier or
AV equipment rack.

Label speaker wires at each end with left/right or specific cable ID and the room
location.
Impedance Matching for Amplifiers and Speakers
If you intend to use more than one pair of speakers at a time it’s important to
consider both the impedance of the speakers and the capabilities of the amplifier
you’re using. Not all amplifiers can safely operate two sets of speakers at once.