4
REMEMBER
–
You own the best. If repairs are needed, use
only purchased parts from authorized distributors.
3. ASSEMBLING INSTRUCTIONS
UNPACKING FROM DOBLE STACK
1.
Remove the saw and all components from its shipping crate. You will see:
Preassembled Saw with no Blade, unless diamond blade was purchased
separately and asked to be installed before shipping.
If asked, you will find saws in double stack and handles attached separately.
Note: All installation hardware must be inserted into its respective location on the
saw, see parts explosion for more details.
2.
If saw is shipped double stack, using appropriated equipment, hold the upper saw
from the frame, unbolt the upper saw from the supports, and bring the saw to the
ground and then proceed to bring the lower saw to the ground, using the same
appropriated equipment.
Warning: failure to use proper lifting equipment could cause
saw to fall and cause serious injury.
3.
If saw is shipped regular, using appropriated equipment, bring the saw to the ground
from its shipping pallet.
4.
Unbolt the handle control assembly, flip it over into the walk behind style, and
proceed to bolt again and torque to 60 ft.-lbs.
5.
Bring the saw up using the crank lift and lock at the desired position and lock handle.
ARBOR OR ENGINE SHEAVE INSTALLATION/REMOVAL
1.
Standard sheaves on this saw are of the QD design. To remove sheave, remove
belt guard and remove belts.
2.
3 remove (3) hex head cap screw from (position A) sheave bushing.
3.
Install (3) caps screw in tapped holes in (position B) sheave bushing.
4.
Tighten tree caps screw alternately and equally until sheaves loosens from
bushing.
5.
Loosen set screw over keyway in bushing and remove sheave/bushing.
6.
Wipe all parts clean before assembly. A light coat of grease can be applied to
engine shaft or arbor shaft. Do not place lubricants on tapered bore of sheaves,
tapered hub of Q.D. bushing or bolt threads.
Discount-Equipment.com
