13
www.tkequip.com
(956) 796 - 9411
use abrasive blades that have been damaged i.e. missing blotters cracked or
missing sections. Inspect diamonds blades to make sur
e they don’t have missing
segments or stress cracks.
2.
Use only blades rated to operate arbor speed of 3000 RPM. Use only proper size
blade guards on your saw.
IF USING A SMALLER BLADE
THAN 20”
PLEASE CONTACT YOUR
LOCAL DEALER FOR INSTRUCTION IN PULLEY CHANGES OR
BLADE WILL RUN AT A HIGHER SPEED AND MAY CAUSE INJURY!
SAW BLADE INSTALLATION
1.
Place saw on flat surface
2.
Locate set screw/jam nut over right end of rear axle.
3.
Loosen jam nut using the blade nut wrench that comes with the machine
4.
Ensure the capacity of the blade guard matches the diameter of your cutting
blade.
5.
Turn set screw clockwise to remove saw rock on right front and left rear wheels.
6.
Turn set screw counter clockwise to remove saw rock on left front and right rear
wheels.
7.
Using the blade nut wrench, remove the blade shaft nut and outside blade flange.
Install the cutting blade onto the inside blade flange arbor. Re-install the outside
blade flange and blade shaft nut. Tighten securely.
DO NOT overtighten.
