4
** The default password is 123456. If you change it, please replace 123456 in the commands above with the
new password.
*** Always check the location received has been freshly calculated (GPS signal should be V:A). If the signal
status is V:V, it could be that the device has entered Standby Mode. Call the number attached to the device to
wake it out of Standby.
**** Sends the device into Standby Mode until movement is detected by the motion sensors, at which point,
the device activates and resumes normal functioning.
***** To use Data Mode, the device needs to be setup to use the internet. This is discussed in Section 5 below.
****** This command can only be sent from an authorized number
4. OPERATING THE TRACKER BY SMS TEXT MESSAGE
Call the mobile number attached to the tracker and hang-up after it rings once.
The tracker will respond by sending you an SMS as described in Section 3.1 below
Click on the link to open google maps and see the location of the tracker.
4.1 EXPLANATION OF PARAMETERS/CODES IN SMS MESSAGE
Picture I Picture II
Picture I
：
As a real-time positioning information of satellite signal recovery
lat:22.63930 lon:114.17172
：
The real-time GPS position
Speed: 000
This indicates the latest known speed of the unit in KM/H.
T:14/12/11 05:23
Timestamp of the time and date when the GPS position was calculated.
Bat
：
60%
The approximate level of the battery. A value between 10% and 100%, with 100% being fully
charged.
8737000001:
The IMEI (International Mobile Station Equipment Identity) number of this device.
Google Maps link:
This is the link to the Google map showing the position of the tracker unit. Clicking on
the text will open Google maps to show the position of the unit.
Picture II:
H
istorical positioning information, without satellite signal (GPS) recovery but with GPRS (LBS)
