TJM Vehicle Mount Compressor Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-17800.docx
Page 8 of 12
29/05/2019
o
Plug the dual solenoid connectors into the loom; the yellow and black connector to the Rear Locker
Solenoid, and the green and black connector to the Front Locker Solenoid.
o
Plug the compressor motor connector into the Red/White and Black loom connector.
o
Fit ring terminals the ends of the Red and Black 10 AWG wires.
o
Connect the red wire to the battery positive terminal, and the black wire to the battery negative
terminal.
o
Secure the loom to the vehicle at regular intervals to prevent wear.
Notes:
If additional wire is required to reach the battery, use 10 AWG wire or larger.
4.2
Electrical Diagram
Figure 1: TJM Vehicle Mount Compressor Recommended Wiring Diagram
