TABLE SAW
17
GB
Danger! The carbon brushes should
not be replaced by anyone but a
qualified electrician.
Saw Blade Change
1. Ensure that the table saw is not connected
to the mains supply.
2. Use protective gloves. Do not touch the saw
blade with your bare hands.
3. Make sure that the saw blade has been
lowered all the way into the saw table. If
necessary, lower the saw blade by turning
the crank counterclockwise up to the stop
point.
4. Remove the saw blade guard from the
riving knife by loosening the wing screw.
Gently pulling the saw blade guard apart.
See below illustration 1.
5. Loosen the two fixing screws and remove
the bench insert. See below illustration 2.
Warning! Prior to any adjustment,
m a i n t e n a n c e o r s e r v i c e w o r k
disconnect the mains power plug!
Carbon Brushes Inspection
In case of excessive sparking, have the
carbon brushes checked only by a qualified
electrician.
General Maintenance Measures
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished using
it.
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
In order to extend the service life of the tool,
oil the rotary parts once monthly. Do not oil
the motor.
MAINTENANCE
1. Turn off the power tool before any transport
and disconnect it from the power supply.
2. Apply the power tool at least with two
people, do not touch the table extensions.
3. Protect the power tool from knocks, bumps
and strong vibrations such as during
transport in vehicles.
4. Secure the power tool against overturning
and sliding
5. Never use the safety devices for handling or
transporting purpose.
TRANSPORT
6. Make sure that the angle of the saw blade
is set to 0°.
7. Rotate the saw blade all the way out of the
saw table by turning the crank clockwise up
to the stop point. See below illustration 3.
Always check the bench insert in the
process: Immediately replace the
bench insert if it is damaged or is no
longer flush with the saw table.
1
3
2
Riving Knife
65050UK00M100.indd 17
2020/5/27 9:36:18