TABLE SAW
10
GB
Height Adjusting Handlebar
1. Turn the saw and make sure it stand on the
flat ground.
2.
Unscrew the washers and nut from the
crank. See below illustration 1.
3. Mount the crank with the washers you have
already affixed and the lock nuts to the
crank wheel in such a way that the crank will
still turn. See below illustration 2.
M6
×
12
×
20
C
M6
×
12
(
×
20)
Leg Support
1
2
3. Loosen the clamping bolt on the clamping
plate with the ring spanner by a few turns in
an anti-clockwise direction. See illustration 3.
4. Insert the riving knife behind the clamping
plate and push it all the way down.
5.
Gently screw the clamp bolt tight in a
clockwise direction.
6. Align the riving knife so that there is 3-5mm
of space to the saw blade on all sides. See
illustration 5.
7. Fix the riving knife in place by tightening the
clamp bolt by turning it clockwise again.
Riving Knife
1.
Rotate the height adjusting handlebar to
set the blade to the max. cutting depth. See
below illustration 1.
2. Unscrew the bevel limitation stopper, turn
the bevel adjusting handwheel to set the
blade to the 0 position and fasten the bevel
limitation stopper. See below illustration 2.
1
2
Bevel Limitation Stopper
65050UK00M100.indd 10
2020/5/27 9:36:12