Tivax STB-T12, Руководство пользователя

Страница: 16 / 32

15
1.3.2 Connecting to a TV (TV Aerial)
TV Aerial
Table below illustrates the different output from the RF Out connector.
Power Indicator Light TV Out Mode (RF Out) Actual Output
Standby
(Sleep)
Red
Analog Pass-Through
RF signal with analog
programming from analog
broadcast stations
On
(Active)
Green NTSC CH 3/4
Analog RF signal in
channel 3 or 4 converted
from digital programming
contents broadcasted by
digital stations
Connect antenna wire to RF ANTENNA
IN on the rear of the convertor. Connect
the supplied coaxial cable wire from the
CH ¾ terminal (RF Out) to RF ANTENNA
INPUT on the rear of your TV.
To view, tune Ch 3 or 4 on your TV,
choose the channel that does not have
an active or strong signal. Slide the CH
3/4 accordingly.
Analog Pass-Through
Please follow the procedure below
when using Analog Pass-Through
1. Make sure the converter box is in
Standby mode. The power indicator
light should be red; otherwise,
press the Power button on the
converter’s remote control.
2. This step only need to perform once
after connection and it is only
require if you did not scan the local
channel before. Scan analog
channels by following the
instruction of your TV. It is the
same as connecting your TV
directly with an antenna.
3. You must use the remote control
from your TV to change channels.
RF Coaxial cable
to your TV
Over-the-air Antenna
ANTENNA IN TV OUT