Titaniumbaby 5930, Инструкция по эксплуатации, Страница: 26 / 28

EN
10.2.2 Check and make sure there is no twist of the belt. Insert the metal
tongue of carbelt into the carseat buckle until you hear a clear “click”. (fig.9)
Warning! Make sure your child arms are above both diagonal and lap
belt. (fig.26)
11 Removing the cover
11.1 Remove the harness system,shoulder pads and crotch pad according
to steps in 9.1.
11.2 Take off the backrest cover by rasing the cover from down to up.
(fig.29)
11.3 Remove the base cover by rasing the cover from down to up.(fig.30)
12. Assembling the car seat
12.1 Take the seat out from the plastic bag and put the it flatly on floor .
12.2 Connect the elastic string on both sides of the seat base cover onto the
hook on backrest, and put the hook in the hole of seat base.Then make the
backrest from flat to upright position until you hear a clear click.
12.3 Guide the two buckle latches together engage them into the harness
buckle until you hear a clear “click”.
12.4 Pull the harness adjust strap.(fig.30)
13. Cleaning the cover
This child car seat must be used with seat cover as seat cover is an integral
part of child car seat. It plays an important role in ensuring that the system
works properly. Make sure that only approved replacement cover by
manufacturer could be used.
Daily cleaning and care instruction for cover
• Hand wash the cover in cold or warm water.
• Do not dehydrate. Suggest to use towel to absorb water and hang dry.
Note:
• Do not use detergent that contains chlorine bleach.
• Do not use washing machine, dehydration machine and dryer.
Hand wash Do not bleach Do not iron Do not
dehydrate
Rub gently Hang dry