Titanium 88170, Инструкция по эксплуатации

Страница: 5 / 12

5
EN
Fig. 1
!
i
i
i
Charging the rechargeable battery pack
• Attach the desired adaptor head onto the charger.
• Insert the charger into one of the two charging ports
(Fig.1). The charging ports are located on the battery
pack and underneath the control panel. Progress
will be shown by the power indicator display on the
charger as following:
Red (flashing) = Charger and battery
are not connected.
Red (constant) = Battery is charging
Green (constant) = Battery is charged
•
Charging time is approximately 5 hours for
a depleted battery.
The battery pack does not need to be inserted in the
laser level whilst charging via the port on the battery
pack.
Removing and inserting the rechargeable battery pack
• Loosen the battery thumb screw on the base of
the laser level and remove the battery pack.
•
Insert the battery pack, ensuring the metal pins
are aligned. Tighten the battery thumb screw.
WARNING! Do not attempt to
disassemble the battery pack.
HORIZONTAL MEASUREMENT SETUP
Level surface set up
• Select a place as close and practical to the work site as
possible, and ensure that the location is clear of traffic.
•
Place the laser level onto a reasonably level surface
with the lighthouse facing upwards.
VERTICAL MEASUREMENT SETUP
Level surface set up
• Select a place as close and practical to the work site as
possible, and ensure that the location is clear of traffic.
• Place the laser level onto a reasonably level surface with
the control panel facing upwards.
OPERATION
Powering on
• Press the
power button once and the laser level
will power on and begin automatically self-levelling.
When this levelling process is complete, the penta
prism inside the lighthouse will start rotating.
•
If the laser level is outside the self levelling range the
laser level will not level causing the laser beam to flash
continuously. If this occurs, reposition the laser level onto
a level surface until the laser level can level off.
In bright outdoor conditions, visible distance will
be significantly reduced. For outdoor use, it is
recommended to use the included detector.
Powering off
• Press the
power button once and the laser level
will power off.
Speed control
• Press the
speed control button on the remote control
to cycle through various rotational speeds.
Sleep mode
• Press the
sleep button on the remote control to
enter into sleep mode.
• The laser diode will stop spinning and shut off.
(The unit is not turned off in sleep mode).
• Press the sleep button on the remote control to exit
sleep mode.
After 60 minutes of inactivity during sleep mode,
the laser level will turn off automatically.
Tilt alarm
• Once the laser level has been levelled off the tilt alarm
can be enabled by pressing the tilt alarm button. The tilt
alarm indicator light will flash continuously whilst active.
•
If the laser level is disturbed while the alarm is active the
laser level will stop rotating and will need to be powered
off and on again to reset to a level position.
USING THE LASER
(continued)