Page 6
For technical questions, please call 1-888-866-5797.
Item 58058
Sa
F
ety
Opera
ti
O
n
Maintenance
Speci
F
ica
ti
O
n
S
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Function
The Auto-Darkening Welding Helmet is designed to protect the eyes and face from sparks, splatter, and
harmful radiation under normal welding conditions. The Auto-Darkening Filter automatically changes from
a clear state to a dark state when an arc is struck, and it returns to the clear state when welding stops.
Solar cells
This Welding Helmet utilizes high performance solar cells as its power supply, and has a replaceable 3V CR2450
lithium battery as power backup. Refer to Maintenance section for battery replacement information.
Shades
User-selectable variable shades from 5 to 9 and 9 to 13 are adjusted with the Set
Switch, Set Switch, and Range Switch. This product is in full conformity with related
DIN, ISO, EN379 safety standards and ANSI Z87.1-2020 standard.
Filters
The ultra high performance of UV and IR Auto-Darkening filters provides the user’s eyes
and face with full protection against UV and IR radiation during the entire welding process,
even in clear state. The UV/IR protection level is up to shade 15 at all times.
Magnifying cheater Lens
To attach a magnifying cheater lens (sold separately) to the inside of the helmet, slide the cheater lens
into place underneath the tabs located on the lower right and left sides of the Lens Retaining Frame.
Before Welding
The Auto-Darkening Welding Helmet comes ready
for use. Prior to first use, remove the protective film
from both sides of the Front Lens Cover and Inside
Lens Cover (if not already done). Check the Front
Lens Cover to make sure that it is clean, and that
no dirt is covering the four sensors on the front of
the Auto Darkening Filter Cartridge. Also check the
Inside Lens Cover and the Lens Retaining Frame,
and make sure that they are secured in place.
important:
Make sure battery is properly
installed before first use. Helmet is shipped
with one CR2450 Lithium Battery.
Adjust the position of the headband, select the correct
shade number for the welding application, and test
the helmet for proper operation as described below.
Inspect all operating parts before each use for signs
of wear or damage. Any scratched, cracked, or
pitted parts should be replaced immediately before
using again to avoid severe personal injury.
auto
Darkening
Filter
cartridge
Front
Lens
cover
Figure a: Helmet
