Page 2
For technical questions, please call 1-888-866-5797.
Item 58058
Sa
F
ety
Opera
ti
O
n
Maintenance
Speci
F
ica
ti
O
n
S
table of contents
Safety ......................................................... 2
Specifications ............................................. 4
Operation .................................................... 6
Maintenance and Servicing ........................ 9
Parts List and Diagram .............................. 11
Warranty .................................................... 12
WarninG SyMBOLS anD DeFinitiOnS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
iMpOrtant SaFety inFOrMatiOn
When using helmet, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
the warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. it must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
read all instructions before using this helmet!
1.
Do not use the Welding Helmet if the lens is
cracked, if the lens or sensors are dirty, or if
the lens or front retaining frame is loose.
2.
Keep work area clean.
Cluttered
areas invite injuries.
3.
Observe work area conditions.
Do not use
welding helmets in damp or wet locations.
Do not expose to rain. Keep work area well
lit. Do not use auto-darkening helmets in the
presence of flammable gases or liquids.
4.
Keep children away.
Children must never
be allowed in the work area. Do not let them
handle this helmet. Dress properly. Do not
wear loose clothing or jewelry. Keep your hair,
clothing and gloves away from moving parts.
5.
Store idle equipment.
When not in use,
helmets must be stored in a dry location
to inhibit rust. Always lock up helmets
and keep out of reach of children.
6.
Dress properly.
Do not wear loose clothing
or jewelry as they can be caught in moving
parts. Protective gear is essential to protect
against welding rays, some examples are: a
leather welding apron, welding sleeves, jeans
without cuffs, work boots. Wear restrictive
hair covering to contain long hair.
7.
Use breathing and hearing protection.
Wear a NIOSH-approved respirator and
hearing protection when welding.
8.
Stay alert.
Watch what you are doing, use
common sense. Do not weld when you are tired.
9.
Do not weld if under the influence of
alcohol or drugs.
Read warning labels on
prescriptions to determine if your judgment
or reflexes are impaired while taking drugs.
If there is any doubt, do not weld.
