OPERATIONS INSTRUCTIONS
Note
:
Before using the tool, read the instruction
book carefully.
INTENDED USE
This cordless tool is intended for sawing and cutting
wooden materials , soft metals and plastic. It is also
suitable for dry sanding and scraping of small surfaces.
Other uses for the tool will lead to the damage of the tool
and a series of dangers to the operator. This tool is
intended for DIY home use, or occasional professional use.
BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must charge
once before use. When you charge the new battery or one
which has not been used for long periods of time, it may
not reach full charge until after you have discharged it fully
in use and recharge it several times.
WARNING:
The charger and battery pack are
specifically designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because an electrical failure and hazard will
occur.
1. TO CHARGE THE BATTERY PACK
(Fig. 1
& 2)
Warning:
Only use charger TTB450CHR to charge
battery TTP449BAT.
Insert the charger plug into a suitable mains socket.
The red light will illuminate. Insert the battery pack into the
charger. The red light will still be on and the green light will
flash to indicate that charging is taking place. When fully
charged, both red light and green light will illuminate.
If the red light flashes during the charging, it means that a
breakdown or an error happened.
Unplug the charger and remove the battery pack.
Warning:
When battery charge runs out after
continuously use or exposure to direct sunlight or
heat, allow time for the tool to cool down before re-charging
to achieve the full charge.
Warning
: There is an alarm function in the charger:
if there is a problem on the battery pack, the red
light on the charger will flash to indicate that the battery
shall be replaced by a new one.
2. TO REMOVE OR INSTALL BATTERY
PACK
(Fig. 3)
To remove the battery pack(2) from the tool, firmly press
and hold in the battery pack release button(A) and slide the
battery pack out of the tool. To install the battery pack, align
raised rib on battery pack with groove inside tool, slide the
battery pack fully onto the tool until the battery pack “clicks”
Fig. 1
Fig. 2
Fig. 3
A
10.8V MULTI-CUTTER TTP448HTL
