Titan TTI526COM, Инструкция по безопасности и эксплуатации

Страница: 15 / 22

18V LI-ION COMBI DRILL TTI526COM
Green on
Red off
Power on and fully
charger,defective battey pack
or pack at high temperature
Red on
Green off
Charging
2. TO REMOVE OR INSTALL BATTERY
PACK (Fig. 2 & 3)
To remove the battery pack(6) from the tool,
firmly press and hold in the battery pack release
button(7) and slide the battery pack out of the
tool. To install the battery pack, align raised rib
on battery pack with groove inside tool, slide the
battery pack fully onto the tool until the battery
pack “clicks” into position. Make sure the release
button on battery pack snaps in place and the
battery pack is secured in tool before beginning
operation.
OPERATIONS INSTRUCTIONS
1. ON/OFF SWITCH & VARIABLE SPEED
CONTROL (Fig. 4)
Depress to start and release to stop your drill.
The on/off switch is fitted with a brake function
which stops your chuck immediately when you
quickly release the switch. The variable speed
control enables you to select the best speed for a
particular job. The further you squeeze the control
the fast the drill will operate.
WARNING: Do not operate for long periods
at low speed because excess heat will be
produced internally.
2. FORWARD/REVERSE SWITCH &
SWITCH LOCK (Fig. 4)
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental starting
when not in use. To lock the switch trigger, place the
direction of rotation selector in the centre position.
For drilling and screw driving use forward rotation
(lever is moved to the left). Only use reverse
rotation (lever is moved to the right) to remove
screws or release a jammed drill bit.
WARNING: Never change the direction of
rotation when the chuck is rotating. Wait until
it has topped.
Fig. 4