19
TTB517STP
by TITAN
In
more
detail…
GB
IE
Trouble shooting
Trouble shooting
Suspected malfunctions are often due to causes that the users
can fix themselves. Therefore check the product using this section.
In most cases the problem can be solved quickly.
WARNING!
Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a
similarly qualified specialist if you cannot solve the problem
yourself!
Problem
Possible cause
1. Product does
not start
1.1 Not connected to
power supply
1.2 Product not switch on
1.3 Power cord or plug
is defective
1.4 Other electrical
defect to the product
2. Product does
not reach full
power
2.1 Extension cord not
suitable for operation
with this product
2.2 Power source (e.g.
generator) has too low
voltage
2.3 Air vents are
blocked
3. Fasteners jam
in tool
3.1 Wrong size fasteners
3.2 Driver channel worn
3.3 Bent fasteners
3.4 Loose magazine/nose
screws
3.5 Broken/chipped driver
1.1. Connect to power
supply
1.2 Switch ON
1.3. Check by a
specialist electrician.
1.4. Check by a
specialist electrician
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3.1. Use only
recommended
fasteners
3.2. Replace nailer
/stapler
3.3. Discontinue using
these fasteners
3.4. Tighten all screws
3.5. Replace
nailer/stapler
Solution
