Titan TTB428GDO, Руководство по эксплуатации

Страница: 7 / 15

SCARIFIER 1300W TTB428GDO
3
5
6
3
4b
4a
2
3
6
5
4b
4a
6
7
6
8
2. ASSEMBLY INSTRUCTIONS
Follow the operating instructions step-by-step and use the
pictures provided as a visual guide to easily assemble the
machine.
1). HANDLE BAR ASSEMBLY
a). Align the lower hand bars (6) with the supports (8). Make
sure the holes in the lower handle bars
correspond those in the supports (8) and secure the bars
with one screw (7) each to the support (8).
(See Fig. 1a, 1b).
1. INTENDED USE
1). This scarifier and raker is designated with a rated input
of 1300 Watts. Depending on the fitted cutting device this
product it is either intended for scarifying and removing
thatch from lawns or for raking in domestic and hobby
gardens.
2). When used as a scarifier, this product works by
scratching through and between the grass with specially
adapted prongs that collect and remove any unwanted parts
from the lawn whilst leaving the grass blades intact. At the
same time the product scarifies the ground resulting in a
better airing.
3). When used as a raker, the fine needles will scratch the
surface of the lawn while simultaneously picking light debris
for better oxygen absorption, airing and draining.
4). This product is not to be used in wet weather conditions
and may not be used to mow dry, wet or unusually high
grass, e. g. pasture grass or for shredding leaves.
5). This product is intended for private domestic use only,
not for any commercial trade use. It must not be used for
any purposes other than those described.
b). Align the middle handle bars (5) to the lower ones (6).
Make sure the holes of the handle bars (5, 6) correspond
and secure them with one mounting set (4) on each side.
(See Fig. 2).
c). Slide the cord strain relief (2) onto the upper handle bar
(3). (See Fig. 3).
d). Align the upper handle bar (3) with the middle handle bar
(5) and secure them with one mounting set (4) on each side.
(See Fig. 4a,4b).
Fig. 2
Fig. 3
Fig. 4a
Fig. 4b
Fig. 1a
Fig. 1b
OPERATION INSTRUCTIONS
WARNING! Read all instructions carefully. Do not
connect the scarifier to mains supply power before
it is completely assembled. Always wear glove s during
assembly.