Titan TTB428GDO, Руководство по эксплуатации

Страница: 11 / 15

SCARIFIER 1300W TTB428GDO
22a
22b
4. GRASS CATCHER
1). Inspect the grass catcher (15) before each use. Do not
use it if you find any damage.
2). Clean the grass catcher (15) after operation. Let the
grass catcher dry thoroughly before storing to avoid mildew.
5. TRANSPORTATION
1). Switch the product off and disconnect it from power
supply before transporting it anywhere.
2). Attach transportation guards, if applicable.
3). Adjust the cutting depth to the transportation stage (refer
to “CUTTING DEPTH ADJUSTMENT”).
4). Always transport the product by its handle.
5). Protect the product from any heavy impact or strong
vibrations which may occur during transportation in vehicles.
6). Secure the product to prevent it from slipping or falling
over.
2. REPLACING/CHANGING CUTTING DEVICE
WARNING!
Always switch the product off,
disconnect it from power supply and let it cool down
before changing/replacing the cutting device!
WARNING!
Always use a correct cutting device
according to the intended use! Observe the technical
requirements of this product (see section Technical
specifications) when purchasing and using cutting devices!
WARNING!
Make sure two bolts are tight completely
before operate the product, don't operate the product
if anyone of bolt is missing or loose.
If bolt thread is damaged, it must be replaced for safety
cause. You can replace it with one suitable size.
Cutting devices are very sharp and become hot
during use! Handle them carefully!
Wear safety gloves when handling cutting devices in order
to avoid injuries like burns and cuts!
The product has two functions, scarifying or raking. The
scarifying cylinder is preassembled on the product. The
raking cylinder is included in the supply box. The cylinder
can be changed according to different application. (See Fig.
11a, 11b)
1). Remove the grass catcher .
2). Place the product upside down on a flat stable ground to
have access to the underbody.
3). Loosen the two bolts (22a) with a suitable wrench,
remove them together with the spring washers (22b) and
the presently attached cutting device (21 or 23). (See Fig.
12a).
4). To remove the cutting device, first lift the bearing and
then pull it out from the drive shaft (25).
5). Align and insert the respective cutting device: Slide
the hex nut into the socket of driving shaft (25) and fix
the bearing to the support with the bolts (22a) and spring
washers (22b). (See Fig. 12b).
3. AFTER USE
1). Switch the product off, disconnect it from the power
supply and let it cool down.
2). Check, clean and store the product as described below.
scarifying cylinder with blades
raking cylinder with fine needles
Fig. 11a
Fig. 11b
Fig. 12a
Fig. 12b