9
www.titan-‐appliances.com
Installing the
Door Handle and Shelves
THE DOOR HANDLE:
1.
Open the door, carefully pull the door gasket around the area where the handle is to be installed,
and remove the two pre-‐installed decorative plugs from the front of the door.
(Note: some models
do not have decorative plugs installed.)
2. Insert the Phillips head screws through the gasket side of the door and pass through the door.
3. Align the handle with the screws and hand-‐tighten using a Phillips head screwdriver until the handle
is flush against the door frame.
(CAUTION: Do not over-‐tighten the screws as this may cause
damage to the handle or to the stainless steel door.)
4. Carefully press the door gasket back into its original position.
THE SHELVES:
This appliance is equipped with pull-‐out roller shelves.
To install:
•
Open the door completely -‐ make sure to open the door all the way before pulling the shelves
out of their track to prevent damaging the door gasket.
•
Slide the shelf on the shelf track and gently push back until it stops.
To remove:
•
Open the door completely-‐ make sure to open the door all the way before pulling the shelves
out of their track to prevent damaging the door gasket.
•
Remove all the contents sitting on the shelf, if any.
•
Pull approximately one-‐third (1/3) of the shelf out.
•
Use a long flat screwdriver to press down the right plastic notch as shown in Figure A .
•
At the same time, lift the left plastic notch as shown in Figure B.
•
Then proceed to pull out the shelf slowly.
Figure A
Figure B
