Titan TN-1341, Инструкция по эксплуатации

Страница: 16 / 31

16 TN-1341 INSTRUCTION MANUAL
BOBBIN WINDING
Before you wind your first bobbin, you
will need to set up the thread guide for
the bobbin winder.
1. Attach bobbin winder thread
guide 1 to the top cover using
screws (Fig 12, Item 2). Pay
close attention to the two
screws. They are used to adjust
the bobbin winding (see below)
WINDING A BOBBIN
1. If your machine has a thread guide pin, pass the thread in the order of 1, through 4.
2. Pass the thread thru one of the holes on the bobbin from inside out.
3. Engage bobbin winder lever A.
4. TO ADJUST THE CAPACITY OF THE BOBBIN: Loosen set screw B and adjust the position of the
adjusting plate to wind a
bobbin about 80~90 % of
its capacity.
5. If the bobbin is wound
unevenly, correct it by
loosening the bobbin
winder thread guide
screws (Fig 13, Items D)
and moving the guide
back and forth to
balance the thread on
the bobbin.
6. Then, tighten set screws
D.
7. When the bobbin is filled
up, the bobbin winder
lever automatically releases the bobbin, and the bobbin winder stops.
Figure 12
Figure 13