Titan SF2843, Инструкция по безопасности и эксплуатации

Страница: 11 / 20

18V JIG SAW SF2843
Fig 3
3. To remove or install battery pack
Locate latches on side of battery pack and
depress both sides to release battery pack from
your saw. Remove battery pack from your saw.
After recharge insert the battery pack into saw’s
battery port. A simple push and slight pressure
will be sufficient.
4. Lock off switch
Your switch is locked off to prevent accidental
starting. Depress lock off button (1) then on/off
switch (2) and release lock off button (1). Your
switch is now on. To switch off just release the on/
off switch (See fig3).
The jig saw can be turned ON or OFF by squeezing
or releasing the switch. The speed of the blade
can be adjusted by the pressure you apply to
the switch. To increase the speed, apply more
pressure to the switch. To decrease the speed,
apply less pressure.
5. Hand grip areas
Always ensure you maintain a firm grip while
operating your jigsaw.
6. Bland clamp holder
You can only use the blade bayonet type (See
fig4a) and U type (See fig4b). At first, put the base
plate up right position, then depress the blade
clamp button (11) (See fig5), then fully insert the
blade into the blade holder slot with blade teeth
facing forward and release the button. Push the
blade into the blade holder again to ensure it is
locked in position. Ensure the edge of the blade is
located in the groove of the blade guide.
Warning: blade teeth are very sharp,
wear gloves when changing blades.
For best cutting results ensure you use a blade
suited to the material and cut quality you need.
Fig 4a
Fig 4b
Fig 5
1 2
11
SF2843 CSJ18P-M-060419.indd 11 2006-5-25 16:38:16