Titan SF230J, Инструкция по безопасности и эксплуатации

Страница: 6 / 16

ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR ANGLE
GRINDER
1. If the supply cord is damaged have it replaced by a qualified person.
2. Check that the speed marked on the wheel is equal to or greater than the rated speed
of the grinder.
3. Ensure that the wheel dimensions are compatible with the grinder.
4. Abrasive wheels shall be stored and handled with care in accordance with
manufacturer’s instructions.
5. Inspect the grinder wheel before use. Do not use chipped, cracked or otherwise
defective products.
6. Ensure that mounted wheels/discs and parts are fitted in accordance with the
manufacturer’s instructions.
7. Ensure that the abrasive product is correctly mounted and tightened before use and
run the tool at no-load for 30 seconds in a safe position. Stop immediately if there is
considerable vibration or if other defects are detected. If this condition occurs, check the
machine to determine the cause.
8. If a guard is supplied with the tool never use the tool without such a guard.
9. Do not use separate reducing bushings or adapters to adapt large hole abrasive
wheels.
10. For tools intended to be fitted with a threaded hole, ensure that the thread in the
wheel is long enough to accept the spindle length.
11. Check that the work piece is properly supported.
12. Do not use cut off wheel for side grinding.
13. Ensure that sparks resulting from use do not create a hazard e.g. do not hit persons,
or ignite flammable substances.
14. Ensure that ventilation openings are kept clear when working in dusty conditions.
If it should become necessary to clear dust, first disconnect the tool from the mains
supply (use non metallic objects) and avoid damaging internal parts.
15. For cleaning, always use eye and ear protection. Other personal protective equipment
such as dust mask. gloves, helmet and apron should be worn.
16. The wheel continues to rotate after the tool is switched off.
17. Always check walls to avoid hidden power cables and pipes in internal walls. A metal
detector can be obtained from any good DIY store for this purpose.
18. Do not touch the workpiece immediately after grinding as it will be very hot.
19. Do not hold unsecured work in your hand.
20. Do not use the grinder as a fixed tool.
21. Do not try to cool the grinding disc with water.
22. Always use the appropriate safety equipment that is required for the product. e.g.
Goggles / Safety Spectacles, Ear defenders (essential with tools with a noise rating of
over 85 dbA), Gloves and face masks. In all cases ensure that the safety equipment is
in good condition.
23.Ensure that if a side handle or stabilising handle is provided with the power tool,
that these are adjusted into a comfortable position and that both handles are used to
securely grip the power tool when in use.