Titan SF230J, Инструкция по безопасности и эксплуатации

Страница: 10 / 16

OPERATION INSTRUCTIONS
WARNING:
Before using your angle grinder
be sure to read the instruction manual
carefully.
1. INSTALLING THE AUXILIARY HANDLE
(see fig1)
An auxiliary handle is supplied and can be fixed
into any of the three positions on the gearcase. If
you are right handed fit the handle as shown in
fig1. If you are left handed fit the handle the other
way round. When using a cutting disc, you can
screw the handle into the position on top of the
gearcase.
NOTE:
This handle should be used at all times to
maintain complete control of the tool.
2. ADJUSTING WHEEL GUARD
(see fig2)
Adjust the guard to protect your hands and direct
grinding debris. Loosen the clamp lever. Position
the guard at the required angle. Then tighten the
clamp lever.
If the guard is still loose when the clamp lever
is tightened, loosen the clamp lever, and screw
down the nut on the guard. Then tighten the
clamp lever again until the guard is secured and
will not move in use.
3. FITTING THE DISCS
(see fig3a, fig3b, fig3c)
Put the Inner flange onto the tool spindle. Ensure it
is located on the two flats of spindle (see fig3a).
Place the grinding disc on the tool spindle and
disc flange. Ensure it is correctly located. Fit the
threaded outer flange making sure it is facing in
the correct direction for the type of disc fitted.
For cutting disc, the flange is fitted with the raised
portion facing away from the disc (see fig3b).
Press in the spindle lock button and rotate the
spindle by hand until it is locked. Keeping the lock
button pressed in, tighten the outer flange with
the spanner provided. (See fig3c)
WARNING:
Never use discs with the Max
specified rotation speed smaller than 6,650/
min (80m/s).Do not attempt to operate the spindle
lock button while the disc is rotating.
4. SWITCH
(see fig4)
The On/Off switch is incorporated with a safety
Fig 3a
Fig 3b
Fig 2
Fig 1
Inner flange
Grinding disc
Outer flange
Inner flange
Cutting disc
Outer flange
A
B