Titan SF185R2, Инструкция по безопасности и эксплуатации

Страница: 10 / 16

OPERATION INSTRUCTIONS
WARNING:
Before using your circular
saw, be sure to read the instruction manual
carefully.
1. ADJUSTMENTS
With this saw there are two things you can adjust:
the blade cutting depth and the mitre cutting
angle.
2. CUTTING DEPTH ADJUSTMENT
(see fig1)
1. To adjust the blade cutting depth, face the saw
away from you.
2. Loosen the cutting depth adjustment knob
which is located at the back of the saw guard.
3. Hold the base plate flat against the edge of the
workpiece and lift the main body until the blade is
at the required depth.
4. Firmly tighten the cutting depth adjustment
knob.
3. MITRE CUTTING
(see fig2)
1. For mitre cutting undo the mitre cutting
adjustment knobs which can be found at the front
and back of the metal base plate.
2. Twist the main body until the required angle is
reached. Use the mitre adjustment guide to help
set the required angle.
3. Tighten the screw to secure the baseplate.
4. USING THE CIRCULAR SAW SWITCHING ON
(see fig3)
1. Connect the plug to the mains power supply.
2. Make sure your circular saw switch is locked off
to prevent accidental starting.
To start the unit, press and hold the safety button,
then press the trigger switch.
NOTE:
The machine has a soft start system,the
blade will take a second or two to reach maximum
speed.
5. SWITCHING OFF
To switch off the unit, release the trigger switch.
The blade may continue to rotate after the trigger
switch has been released. Wait until the unit has
come to a complete stop before setting down.
6. USING THE PARALLEL FENCE
(see fig4)
A parallel fence allows you to make parallel cuts
in sheets of wood which are consistently the
Fig 3
Fig 4
Fig 2
Fig 1