10
”
TABLE SAW SF10N1
main body of saw .(See Fig 12)
Mount the vacuum nozzle over the side B of the
hose and fix it with the four screws. (See Fig12A)
5.Elevating & Lowering Handle
Mount the tilting handle on the shaft on the left
side of the saw and fix it by tightening the set
screw in the handle. (See Fig14&15)
6.Mounting The Rip Fence
Mount the rip fence so that the side with the
indicator is on the motor side. (See Fig15A) First
fully loosen the locking handle and mount the
front side so the fence contacts the front side of
the table and then the back side so that the fence
is level on the table. Be sure both locking plates
are in contact with the both the front and back
edges of the table. (See Fig15B)
OPERATION CONTROLS
1) On-Off safety switch
WARNING
: Before turning on the switch make
sure the blade guard is correctly installed and
Operating properly.
To start the machine push the switch to the ON
position. (See Fig16) When turning the switch
ON stand on either side of the blade and never
in front of it.
Allow blade to reach full speed before cutting.
To stop the machine push the switch to the OFF
position.
2) Elevating and lowering handle
The elevating and lowering handle is used
to raise and lower the blade. Turn clockwise
to lower the blade and anticlockwise to
raise it. (See Fig18)
3) Tilting handle
The tilting handle is used to tilt the blade for bevel
cutting.Loosen the tilting handle lock knob , then
Turn the tilting handle clockwise to tilt toward
the left and anti-clockwise to tilt toward the right.
(See Fig19)
4) Lock knob
The handle locks the blade in the desired tilting
angle. To loosen turn it anti-clockwise.
When setting the angle of the cut fully loosen
it. Before turning the table saw ON, be sure it is
securely tightened so that the blade will not shift
during the table saw operation. (See Fig19)
5) Riving knife
This separates the saw kerf in a workpiece.
This prevents possible binding and kickback.
Fig 7
Fig 5
Fig 6
Fig 8
Содержание SF10N1
Страница 1: ...10 TABLE SAW SF10N1 SAFETY AND OPERATING MANUAL...
Страница 14: ...Fig 28 Fig 26 Fig 27 Fig 29 Center cover A B Fig 25 Fig 24 Fig 22 Fig 23...
Страница 15: ...10 TABLE SAW SF10N1...
Страница 18: ......
