Titan SF10N1, Инструкция по безопасности и эксплуатации

Страница: 8 / 18

OPERATION INSTRUCTIONS
Warning: Before using your table saw,
read the instruction manual carefully.
ASSEMBLY OF THE TABLE SAW
Assembly of the table saw
1. Support leg
1) Take the assembly out of packaging.Pick out two
main legs ,one bracket, then fix bracket onto the
legs with the bolts provided, but do not tighten
(see Fig1). Assemble another section like this.
2)Mount another two brackets onto each section
(see fig 2). Then stand these two sections upright
and fix them together with the bolts provided.
Be sure to tighten all bolts (see fig 3) Your table
should now look like fig 4.
3)Before going any further turn the saw unit
upside down and remove the bottom safety cover
(see fig 13). Now use the tilting handle (see fig
14)to tilt the saw blade until the transportation
foam pad around the motor can be removed.
Refit the bottom safety cover.
4)Turn the saw upside down. Insert the previously
erected table section into the base of the saw unit
and fix them together with the bolts provided. Be
sure to tighten all bolts.
2. Extension table
Position one extension table on the main table,
and fix them by nuts provided (see Fig6). Take
out two supporting bars, remove the mounting
screws on machine (see Fig7) , position the bars,
and remount the screws(see Fig8), then securely
fix the other bars with bolts (see Fig9).Repeat this
operation on the other side of the table
3. Fitting the Saw Safety Guard
Put the guard on the riving knife and be sure the
securing bolt can pass through the hole on the
guard (see Fig10). Fix the guard with flat washer
and anti-loose nut provided, but do not tighten it,
let the guard rotate easily (see Fig11).
4.Fitting the Dust hose & Vac Hose
Connector Bracket
(Lay the table saw upside down on its table)
1.Mount the side A of the hose on the dust
collector nozzle of the blade guard under table
and fit the side B of the hose on the outlet of the
Fig 3
Fig 1
Fig 2
Fig 4