Titan SF08N5, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

8
”
TABLE SAW SF08N5
tighten the securing knobs.
Note:
If a precision 90
O
cut is required, check the
angle of saw blade using a square, make any
adjustments necessary using the adjuster handle,
then reset the pointer.
Clearly mark the work-piece where the cut
is required. Hold work-piece firmly and feed
through saw blade, ensuring feed is straight (DO
NOT attempt to cut curves).
If sawing long sections arrange supports at one
or both sides of machine as required and not use
rip fence. (See Fig 8)
6. BEVEL CUTTING
Rip and crosscuts can be made at angles between
0
O
~45
O
. Slacken the table angle securing knobs,
front and rear (See Fig 9).
Turn the adjuster handle as required to the
desired angle as indicated on the scale. Tighten
both securing knobs. Proceed to cut as for rip or
cross cutting.
7. DUST EXTRACTION
This table saw is equipped with a dust extraction
port at the rear of the machine (See Fig 10) For
safe operation, we recommend that a suitable
dust extraction device or vacuum cleaner be
connected during operation.
Warning: Excessive sawdust built
up around the motor could possibly
ignite and cause damage to either the
motor, table saw or your workshop.
Fig 10