Titan 50SPREAD, Руководство пользователя

Страница: 5 / 12

5
5. Slip Inner Axle Bushing (#37) onto the right side of the axle, pushing the Inner Axle Bushing
into the Outer Axle Bushing until tight. Attach Wheel (#36) to the right side of the axle by inserting
a M5 x 45 bolt (#47) and fastening with Lock Nut M5 (#44). Attach Axle End Cap (#35) by tapping
with a wooden or rubber mallet.
b) Slip Inner Axle Bushing (#37) onto the left side of the axle, pushing the Inner Axle Bushing into
the Outer Axle Bushing until tight. Push the Wheel onto the axle. Insert nylon washers
（
#52
）
to
the two sides of the wheel, then insert Flat Washer Ø16 (#34) and attach Axle End Cap (#35) by
tapping with a wooden or rubber mallet. NOTE: The nuts and bolts do not have to be completely
tightened yet.
Note: Insert the Inner axle
bushing into the outer axle
bushing and make sure they
are tight.
6.
Insert Handle Shaft (#26) between the top ends
of the Wheel Assembly Frames (#20). Pass two
Bolts M6 x 45 (#11) through Wheel Assembly
Frames and Handle Shaft. Slip Pivot and Bracket
Assembly (#19) onto protruding bolt ends. Fasten
with Lock Nuts M6 (#24). Pivot and Bracket
Assembly should be on the right side of the
handle when standing behind the spreader.
GO BACK AND TIGHTEN ALL NUTS AND
BOLTS ASSEMBLED SO FAR. DO NOT OVER
TIGHTEN.
NOTE:
The handle can be higher or lower
depending on the user’s preference. Before
installing the gauge, upper handles and handle
shaft, decide which of the three positions will be
most comfortable for the operator. If the middle or
upper positions are chosen, use a handle spacer
in the hole nearest to the handle grips.
5
6