Titan Pro TP 700, Руководство по эксплуатации

Страница: 10 / 22

9
RESTATING
RESTATING
RESTATING RESTATING A
A
A A WARM
WARM
WARM WARM ENGINE
ENGINE
ENGINE ENGINE
Restarting an engine that is already warn from previous running does normally require use of the
choke.
1. Move throttle lever to “start” position.
2. Pull starting rope out rapidly until engine starts. Allow rope to return normally. Repeat until
engine starts.
3. Adjust throttle speed to “high” for best tiller action.
IDLE IDLE IDLE IDLE SPEED SPEED SPEED SPEED
Use the “low” position on the throttle lever to
reduce stress on the engine when tilling is
not being performed. Lowering the engine
speed to “idle” will help extend the life of
the motor, as well as conserve fuel and
reduce the noise level of the equipment.
OPERATING OPERATING OPERATING OPERATING SPEED SPEED SPEED SPEED
For normal tilling, set the throttle lever to “fast”.
SHUTTING SHUTTING SHUTTING SHUTTING DOWN DOWN DOWN DOWN
To stop the engine at any time, turn engine ON/OFF switch to the off position. To stop wheels and
tines at any time, release drive safety control levers to neutral position.
TILLING TILLING TILLING TILLING
1 Adjust the depth regulator lever to desired tilling depth.
NOTE: NOTE: NOTE: NOTE: Raise Raise Raise Raise depth depth depth depth regulator regulator regulator regulator lever lever lever lever up up up up one one one one hole hole hole hole at at at at a a a a time, time, time, time, testing testing testing testing tiller tiller tiller tiller operation operation operation operation after after after after each each each each
raise. raise. raise. raise. Raising Raising Raising Raising depth depth depth depth regulator regulator regulator regulator lever lever lever lever too too too too high high high high can can can can result result result result in in in in loss loss loss loss of of of of control control control control of of of of tiller tiller tiller tiller!!!!
2 2 2 2 Move the throttle control to fast.
3 Place the tiller in forward by pushing down on the drive safety control lever(FORWARD)—this
will engage the wheels and tines.
NOTE: You can slow the tiller’s forward advance at any time by putting slight downward pressure
on the handlebars. You can stop the tiller by releasing the drive safety control levers to the neutral
position.
DRIVE DRIVE DRIVE DRIVE SAFETY SAFETY SAFETY SAFETY CONTROL CONTROL CONTROL CONTROL LEVERS LEVERS LEVERS LEVERS
FORWARD FORWARD FORWARD FORWARD LEVER LEVER LEVER LEVER