Titan Logix CTX-TDS-100, Руководство по настройке утилиты

Страница: 32 / 39

TPM 054 Version 1.0, May 30, 2016 Page | 30
SOFTWARE
Configuration Utility Manual
CONFIGURATION AND COMMUNICATION TEST PROCEDURE
Perform the following steps before carrying out any custom configuration. This procedure is intended to
be used by installers and service technicians.
Step Detail
1. Power up the
Gateway
a) Turn on the Gateway module by turning on the vehicle
electrical accessory power or connecting to a fully
charged battery power source
b) Wait until the status indicator starts flashing (this could
take up to 2 minutes)
c) Observe that the status indicator is blinking 1/2s ON and
1/2s OFF
2. Launch the
Gateway
Configuration
Utility -
Standard
a) Establish a Wi-Fi connection with the Gateway
b) Save the configuration settings using the Gateway
Configuration Management procedure in this manual
c) Click the “Gateway Status” selection
3. Optional –
Customized
Configuration
a) Go to the Gateway Configurations page
b) Click “Open From File”
c) Browse to the configuration file folder (new file provided
by Titan)
, click on the filename, then click “Open” (the
filename ends in .gwu and is supplied by Titan)
d) Confirm that the new settings are correct
e) Save new settings to the Gateway by clic king “Upload to
Gateway” button
f) Restart the Gateway device
g) Reconnect to the Gateway via Wi-Fi
h) Go to the Gateway Status page
4. Check the
Cellular
Status
a) PPP Link Status, checked
b) Signal Strength, good
5. Check the
Remote
Server Status
a) Communication Established