Titan Lifts HD2P-13KCL, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 40

3
• Maintenance or repair work should be done by authorized service personnel only.
• Work on the electrical equipment should be done by certified licensed electricians only.
• Ensure that ecologically harmful substances are disposed of in accordance with the
appropriate regulations.
• To prevent the risk of damage, do not use high pressure / steam jet cleaners or caustic
cleaning agents.
• Do not replace or override the safety devices.
WARNING: Risks the personnel could encounter, due to an improper use of the lift, are
described in this section.
CRUSHING RISK
During lowering of runways and vehicles, personnel must not be within the area
covered by the lowering trajectory. The operator must be sure no one is in danger before
operating the lift. Stay clear of the lift when lowering or raising vehicles. Keep hands and feet
away from moving parts and especially points that could pinch. Keep your feet clear of the
lift when raising and lowering vehicles.
RISK OF THE VEHICLE FALLING FROM THE LIFT
Risk of the vehicle falling from the lift is increased: when the vehicle is improperly placed on
the platforms, when the vehicle’s weight or physical dimensions exceed the rated capacity
of the lift, or when there is excessive movement of the vehicle while on the lift. If vehicle
appears to begin falling, exit the area as quickly as possible to avoid injury. Always position
vehicle with the center of gravity midway between the adapters. Adding or removing parts
of a vehicle on the lift will alter the weight displacement on the lift. Therefore, use of auxilary
safety stands in the front and back of the vehicle is recommended. Never override the
manufactured lift controls. Always use height adapter pads when possible to ensure proper
contact. Only authorized personnel should be allowed in the lift area and the lift should only
be operated by authorized and trained personnel. Adding or removing parts of a vehicle on
the lift will alter the weight displacement on the lift.
BUMPING RISK
When the lift is stopped at relatively low working height, the risk of bumping against
projecting parts increases. Always be aware of your surroundings and avoid bumping your
head or body on the lift or the vehicle.
1.4 SAFETY INSTRUCTIONS FOR MAINTENANCE
1.5 RISKS