Titan Electronics NCOM SERIAL 4XX Series, Руководство пользователя

Страница: 27 / 94

26
5.4 Pair Connection Mode
Pair Connection Mode uses two NCOM devices in tandem, with one NCOM device in
Pair Connection Master Mode and the other in Pair Connection Slave Mode. Two
NCOM serial device servers are then connected to each other through Ethernet. Both
may either be connected to the same LAN or over a WAN (i.e. through one or more
routers). Pair Connection Mode transparently transfers both serial data and modem
control signal without distance limitation.
When setting two NCOM-413 devices in Pair Connection Mode, you need to set the
“Destination IP Address” of the master serial device server as the IP address of the
slave serial device server.
Under the “HOME” page of NCOM-413’s firmware, select “NETWORK SETTINGS” to
find the “Port 1/2/3/4 Mode Settings” window. Under “Mode”, select “Pair
Connection - Master” and type “Destination IP address” and “Port” of the slave serial
device server respectively (e.g. 192.168.254.250 Port: 2000) to connect to a serial
device server in Pair Connection Slave Mode. Check the “Make these the default
settings” box and click “Apply Changes” to set two NCOM-413 devices in Pair
Connection Mode.