Titan Attachments 191539, Руководство оператора

Страница: 10 / 34

10
MOWER INSTALLATION
NOTE: The illustrations and instructions provided explain how to install a bucket
attachment on to a loader. Follow these same instructions if you are installing different
attachments such as a grapple, tiller, mower, etc. The attachment mounting frame for
the attachment has a top flange that is designed to receive the top edge of the Bob-Tach
and the lower part of the frame is designed to receive the Bob-Tach wedges.
IMPORTANT: Always inspect the loader’s Bob -Tach and the attachment mounting frame
before installation.
a. Pull the Bob-Tech levers up until they are fully raised (wedges fully raised). Refer to
Figure 1-8 .
b. Enter the loader, start the engine, press the PRESS TO OPERATE LOADER button and
release the parking brake.
c. Lower the lift arms and tilt the Bob-Tach forward.
d. Drive the loader slowly forward until the top edge of the Bob-Tach is completely under
the top flange of the attachment mounting frame. Refer to
Figure 1-9.
NOTE: Be sure the Bob-Tach levers do not hit the attachment.
e. Tilt the Bob-Tach backward until the attachment is
slightly off the ground. This will cause the attachment
mounting frame to fit up against the front of the Bob-
Tach. Refer to
Figure 1-10.
FIGURE 1-1
NOTE: When leaving the operator’s seat to install a n attachment, tilt the attachment until it is
slightly off the ground.