19
20
4.11.4 Others
4.11.4.1 Factory Test
Press “Ok” icon of “Factory” and follow the indication to enter factory test
interface.
4.11.4.2 Network Test
Press “test” icon to test the connection status with gateway and server.
4.11.4.3 Restore Factory Test
Press “Ok” icon of “Restore factory” to bring out the prompt box displaying
whether to restore the factory setting. Reconfirm the prompt box, and then
press "Ok" icon to restore the setting. After that, the system will restart
automatically.
4.11.5.4 D-code Function
To activate or shut down the alignment code function.
4.11.3 Area Definition Setting
Press "Area define" icon in project setting interface, enter the area define
setting page to select the place, type, trigger way and state. Area location
includes gate, doors, bedroom, guest room, hall, window, balcony, kitchen,
study and bathroom. Sensor type includes infrared, magnet, smoke, gas
and emergency.Trigger way includes normal closed, normal open, 3-state
low level (the unit will alarm when it is in low level, equipment installation state
detection), 3-state high level (the unit will alarm when it is in low level,
equipment installation state detection).
After setting, press "Ok" to save it. Press to exit the system setting
menu, the equipment will automatically reboot. The configuration will take
effect after reboot.
Note: IP address should be different from other equipments within the
same network. In the same unit, indoor unit and the corresponding
stair unit should be set in the same network segment.
4.11.2 Password Setting
Press “Pwds setting” icon to enter project password setting interface to set
the project password.
·
IP address
：
192.168.1.100
·
Subnet mask
：
255.255.255.0
·
Gateway address
：
192.168.1.1
·
Server address
：
192.168.1.200
Room number setting
·
Building no.
：
0101(Building 1 Unit 1)
·
Room no.
：
0105 (Room 105)
·
Extension doorbell no.
：
1
Network address setting