Tippmann CUSTOM PRO, Руководство пользователя

Страница: 12 / 24

E-TRIGGER
TM
- Mode Settings / Firing Response
Firing Mode Setting . Firing Response Description:
0 = NO OPERATION ....... No response.
1 = SEMI AUTO .............. Fires one shot for each pull of the trigger.
2 = NO OPERATION ....... No response.
3 = AUTO RESPONSE .... Fires one shot for each pull or release of
the trigger. If the trigger is held for an extended period, when the
trigger is released no shot is fired.
4 = NO OPERATION ....... No response.
5 = FULL AUTO .............. Fires shots repeatedly as long as the
trigger is held.
6 = NO OPERATION ....... No response.
7 = 3 SHOT .................... Fires either a 3 shot burst when the
trigger is held or if trigger is released before 3 shot cycle is
complete - firing stops at that point of cycle.
8 = NO OPERATION ....... No response.
9 = TURBO ..................... Fires one shot for each pull of the trigger
until the time between trigger pulls is below .25 seconds - it then
goes to one shot for each pull or release of the trigger.
Problem: If you pull the trigger and marker does not fire.
1) Check to be sure safety is off.
2) Make sure sufficient air supply is hooked up to marker.
3) Firing Mode may be set to “= NO OPERATION”.
With screw driver, turn Mode adjustment, access through top
hole in lower receiver, turn 1 position (click) try trigger again.
4) Battery may be disconnected - check battery clip connection.
5) Battery may be bad - replace battery.
6) Internal wire may be disconnected. Inspect wire connec-
tions inside lower receiver. To do so, first follow the unloading
and air supply removal instructions on page 14 and never
disassemble a marker that is under pressure. Remove left
receiver half as outlined on page 15, then visually inspect in-
ternal wires for disconnected wire end(s). When replacing left
receiver half, be sure wires are positioned in cutout areas so
wires are not pinched or sheared and the armature pin moves
freely (follow instructions on page 11).
If a problem still exists, call Tippmann
TM
Service Department at
1-800-533-4831.
E-TRIGGER
TM
Troubleshooting
E-TRIGGER TM Tuning and Operating Instructions (continued from page 9)
E-TRIGGER TM Troubleshooting (continued on page 11)
10