Tippmann CUSTOM PRO, Руководство пользователя

Страница: 10 / 24

counterclockwise to increase
rate of fire to the
desired speed.
clockwise
to slow the
rate of fire
With a screwdriver, turn the Flow Control Adjustor
Tuning The RESPONSE TM Trigger Rate of Fire
Tuning - Troubleshooting B:
If the trigger remains easy to pull after adjusting the flow control,
there may be a leak in the system. Double check installation
making sure all fittings are tight and o-rings are properly seated.
If you need to disassemble to check that all fittings are tight
and o-rings are properly seated, do not disassemble this
marker while it is pressurized with air, follow disassembly /
assembly instructions on page 15.
If a problem still exists, call Tippmann
TM
Service Department at
1-800-533-4831.
Tuning - Troubleshooting A:
If tuning the Response
TM
trigger produces little or no response
in the rate of fire, reset the Flow Control as follows:
1) With marker properly unloaded (see page 14), begin
adjusting rate of fire by turning flow control clockwise
completely. Do not over tighten or damage will occur. In a safe
direction fire 2 to 4 shots. Trigger should become very hard to
pull or even unable to be pulled. If this occurs, the response
trigger system is functioning properly. Go to step 2. If it does
not occur, go to Troubleshooting B.
2) Now while firing in a safe direction with marker still unloaded,
slowly turn the flow control adjustor counterclockwise until
desired rate of fire is achieved.
NOTE: To disable the Response
TM
System, remove
the universal 90 0 fitting attached to the power tube/
valve and replace it with the shut off plug.
TM
E
N
G
L
I
S
H
8