Timpdon Marine
Tel 0161 - 980 8054
Issue 1 – May 2011
Web
www.timpdon.co.uk
EMail [email protected]
Programming
Programming or re-programming may be performed at any time, using
push button switches
S1
and
S2
, with indication provided by the
LED.
Programming is performed in three steps, in order –
Servo Reset
Position, Servo Set Position
and
Servo Rotation Rate
The
set
and
reset
limit positions of the servo may be set anywhere
within its operating range, subject to a limitation of RC pulse widths of
0.6 ms to 2.4 ms, as described above .
Programming Procedure
Programming may be undertaken with the transmitter either on or
off.
Press and hold both switches
S1
and
S2
together.
The
LED
will flash rapidly for about 5 seconds, and then go on
continuously. Then release both switches.
If you release either switch before the LED stops flashing, the
unit will remain in normal operation.
1
You are now in
Step 1 – Servo Reset Position
The
LED
will flash with
single short
flashes, and the servo will move
to the current
reset
position.
Adjust the required
reset
position using either
S1
to increase the
servo position or
S2
to decrease it. The actual rotation direction is
servo dependent.
When satisfied, press and hold both switches
S1
and
S2
together.
The
LED
will flash rapidly for about 2 seconds, and then go on
continuously. Then release both switches.
If you release either switch before the LED stops flashing, the
unit will remain in program Step 1.
The unit will then proceed automatically proceed to program
Step 2
.
